BAL Level Rapid-Setting Floor Levelling Compound 20kg

A rapid-setting, self-smoothing floor levelling compound, BAL Level Fast can be walked on after only 30 minutes and tiled on after 45 mins. Level Fast can be used from 2mm to 30mm including only 3mm over timber. Formulated with Fibre Strand Technology for extra flexibility and strength, there is no need for spike rolling saving significant project time. With a 10 minute bucket life and 10 minute wet edge, it gives you longer time with each mix.

BAL Level Fast provides the perfect time-saving start to any tiling project with key features including self-smoothing, self-healing and a low-shrinkage technology. With a one-pour technology it can be used over most substrates including concrete, sand:cement screeds, overlaid timber and crucially underfloor heating installations.

Floor levelling compoundfeatures

• High performance rapid-hardening technology
• Self-smoothing, shrinkage compensated with one pour excellent flow
• Suitable for timber floors (minimum thickness 3mm)
• 10 minute wet edge for a perfect seamless base
• 10 minute pot life
• Accepts foot traffic in 30 minutes at 20C
• Tile after 45 minutes
• Bed depth 2mm 30mm
• Excellent coverage: 4m at 3mm thickness
• Protein free formulation
• Greycolour

Bag weight: 20 kgs

Additional information

BAL Level Fast Levelling Compound is suitable for dry internal applications only.

Please note: BAL Level Fast Levelling Compound is not suitable as a wearing surface, for exterior use or total immersion areas (e.g. swimming pools).

Application

DO NOT use BAL Level Fast in temperatures below 5C or in damp conditions.

1. Prime the floor surface if required and allow to dry before mixing. Note: Timber board joints where gaps between boards are open, use thin heavy duty tape to bridge joints, care must be taken not to over everywhere in tape (this will help to minimise the leveller disappearing beneath the sub-floor).
2. Pour mix over sub-floor and spread to required depth using a suitable steel finishing trowel or long hand blade.
3. Surface should be sufficiently smooth to receive floor coverings without further treatment. Note: Do NOT use a spiked roller; this will pull the fibres to the surface. If any trowel marks remain: rub down before compound has hardened (after 3 hours).
4. Allow new floor surface to set. Depending on thickness of application, a 3mm layer of BAL Level Fast can receive foot traffic after 3 hours and receive tiling after 4 hours.
5. Show existing movement joints within the sub-floor and when receive tile finishes.
6. Allow BAL Level Fast to set for 24 hours when receive soft floor finishes (inc. vinyl, linoleum, carpet, resilient and certain floor paints)